
1-29
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 1 General Troubleshooting
Troubleshooting WBE-28 and WBE-84 Cards with Far End Loopcodes on DS1 Ports
Figure 1-4 Diagram of FEAC Circuit
1.4.1 FEAC Send Code
The Send Code column on the WBE-28/WBE-84 cards Maintenance tab only applies to OOS-MA,MT
ports configured for CBIT framing. The column lets a user select No Code (the default) or line loop code.
Selecting line loop code inserts a line loop activate FEAC in the CBIT overhead transmitting to the
connected facility. This code initiates a loopback from the facility to the ONS 15310-MA. Selecting No
Code sends a line-loop-deactivate FEAC code to the connected equipment, which will remove the
loopback.
1.4.2 WBE-28/WBE-84 Inhibit FEAC Loopback
WBE-28/WBE-84 DS3 ports initiate loopbacks when they receive FEAC line loop codes. If the Inhibit
FE Lbk check box is checked for a DS3 port, that port ignores any FEAC line loop codes it receives and
will not loop back (return them). If you inhibit a DS3 port's far end loopback response, this DS3 port is
not restricted from terminal or facility loopbacks.
1.4.3 FEAC Alarms
When an ONS 15310MA - WBE-28/WBE-84 DS3 port receives an activation code for a FEAC
loopback, it raises the “LPBKDS3FEAC” condition on page 2-108. The condition clears when the port
receives the command to deactivate the FEAC loopback. If a node sends a FEAC loopback command to
the far end, the sending node raises a “LPBKDS3FEAC-CMD” condition on page 2-109 for the near-end
port.
1.5 Troubleshooting WBE-28 and WBE-84 Cards with Far End
Loopcodes on DS1 Ports
WBE Cards support Far End Loopcodes when the DS1 port is operating in ESF Framing mode. Click
the WBE-28/WBE-84 Maintenance->DS1 tab to reveal additional columns, namely , "Inhibit FE Lbk"
and "Send Code". Here we are using the term FE Loopcodes instead of FEAC in DS1, since DS1
supports only Far End Loopcodes, but NOT Alarms.
159522
OC-N CE-MR-10XCOC-N
Test Set
XCCE-MR-10
Komentáře k této Příručce