Cisco 15310-MA Průvodce řešením problémů Strana 116

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 380
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 115
1-80
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 1 General Troubleshooting
Circuits and Timing
Step 2 Check the list of available ports. The previously selected port no longer appears in the available list
because it is now part of a provisioned circuit.
Step 3 Select a different available port and begin the circuit creation process.
1.10.14 Calculate and Design IP Subnets
Symptom You cannot calculate or design IP subnets on the ONS 15310-CL or ONS 15310-MA.
Table 1-21 describes the potential cause of the symptom and the solution.
1.11 Circuits and Timing
This section provides solutions to circuit creation and reporting errors, as well as common timing
reference errors and alarms.
1.11.1 Circuit Transitions to Partial Status
Symptom An automatic or manual transition of another state results in the OOS-PARTIAL state; at least
one of the connections in the circuit is in IS-NR state and at least one other connection in the circuit is
in IS,AINS, OOS,MT, or OOS_AINS state.
Table 1-22 describes the potential causes of the symptom and the solutions.
Table 1-21 Calculate and Design IP Subnets
Possible Problem Solution
The IP capabilities of
the ONS 15310-CL and
ONS 15310-MA
require specific
calculations to properly
design IP subnets.
Cisco provides a free online tool to calculate and design IP subnets. Go to
http://www.cisco.com/cgi-bin/Support/IpSubnet/subnets.pl. For
information about ONS 15310-CL or ONS 15310-MA IP capability, refer to
the Cisco ONS 15310-CL and Cisco ONS 15310-MA Reference Manual.
Zobrazit stránku 115
1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 379 380

Komentáře k této Příručce

Žádné komentáře