Cisco 15310-MA Průvodce řešením problémů stáhnout pdf (Strana 314)

4-6

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-2030 An error occurred during provisioning. There was an error during provisioning.

EID-2031 An error occurred while adding the node. There was an error while adding a node.

EID-2032 The circuit could not be renamed.

{0}

CTC could not rename the circuit.

EID-2033 An error occurred during validation.

{0}

There was an internal error while validating

the user changes after the Apply button was

pressed. This error can occur in the Edit

Circuit dialog box or in the BLSR table in

the shelf view (rare condition).

EID-2034 Network circuits could not be added:

{0}

Refer to the error message text.

EID-2035 The source and destination nodes are not connected. Refer to the error message text.

EID-2036 The {0} cannot be deleted.

LAN Access has been disabled on this node and this {0} is

needed to access the node.

You cannot delete the DCC/GCC link as it

is needed to access the node.

EID-2037 The attribute for {0} cannot be found. CTC cannot find an attribute for the

specified item.

EID-2038 The protection operation is invalid. The protection operation you tried to

execute is invalid.

EID-2040 Please select a node first. You must select a node before performing

the task.

EID-2041 No paths are available on this link. Please make another

selection.

You must select a link that has paths

available.

EID-2042 This span is not selectable. Only the green spans with an arrow

may be selected.

Refer to the error message text.

EID-2043 This node is not selectable. Only the source node and nodes

attached to included spans (blue) are selectable. Selecting a

selectable node will enable its available outgoing spans.

Refer to the error message text.

EID-2044 This link may not be included in the required list. Constraints

only apply to the primary path. Each node may have a

maximum of one incoming signal and one outgoing link.

You must select only one link going in and

out of a node. Selecting more than one link

is contradictory to the path selection

algorithm.

EID-2045 This link may not be included in the required list. Only one

outgoing link may be included for each node.

Refer to the error message text.

EID-2047 Please enter a valid value for the slot number. There was an error due to an invalid slot

number.

EID-2048 Please enter a valid value for the port number. There was an error due to an invalid port

number.

EID-2050 The new circuit could not be destroyed. CTC could not destroy the new circuit.

EID-2051 The circuit cannot be downgraded.

{0}

The specified circuit cannot be

downgraded.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 309 310 311 312 313 314 315 316 317 318 319 ... 379 380

Komentáře k této Příručce

Žádné komentáře

Cisco 15310-MA Průvodce řešením problémů Strana 314

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco 15310-MA