Cisco 15310-MA Průvodce řešením problémů stáhnout pdf (Strana 323)

4-15

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-2215 An error occurred while leaving the {0} page. There was an error while leaving the

specified page.

EID-2216 An error occurred while entering the {0} page. There was an error while entering the

specified page.

EID-2217 Some conditions could not be retrieved from the network view Refer to the error message text.

EID-2218 The bandwidth must be between {0} and {1} percent. The bandwidth must be within the specified

parameters.

EID-2219 The protection operation failed. An XC loopback was applied

on the cross-connection.

As the protection operation failed, a

cross-connect (XC) loopback will be

applied on cross-connection.

EID-2220 The tunnel status is PARTIAL. CTC is not able to change it.

Please try again later.

Refer to the error message text.

EID-2221 A valid route cannot be found for the unprotected to {0}

upgrade request.

Refer to the error message text.

EID-2222 One or more of the following nodes are currently part of a

four-fiber {0}. Only a single four-fiber {0} is supported per

node.

{1}

The nodes, specified by {1}, are already

part of a 4-fiber BLSR/MS-SPRing type

(specified by {0}).

EID-2223 Only one circuit can be upgraded at a time. Refer to the error message text.

EID-2224 This link may not be included because it terminates on the

source.

Refer to the error message text.

EID-2225 A valid signal could not be detected while trying to complete

the roll.

{0}

Roll can be completed only when a valid

signal is detected. If not, the roll completion

may result in an error.

EID-2226 The circuit roll failed.

{0}

Refer to the error message text.

EID-2320 This VCAT circuit does not support deletion of its member

circuits.

You can not delete a circuit that is a member

of VCAT circuit.

EID-2321 An error occurred while deleting member circuits.

{0}

Refer to the error message text.

WID-2322 Not all cross-connects from selected circuits could be merged

into the current circuit. They might appear as partial circuits.

Refer to the warning message text.

EID-2323 The circuit roll failed.

Bridge and roll is not supported on monitor circuits.

A monitor circuit does not support Bridge

and Roll.

EID-2324 An error occurred during the circuit upgrade.

{0}

Refer to the error message text.

EID-2325 You have failed {0} times to unlock this session. CTC will exit

after you click OK or close this dialog box.

The maximum amount of attempts to

unlock this session has been reached.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 318 319 320 321 322 323 324 325 326 327 328 ... 379 380

Komentáře k této Příručce

Žádné komentáře

Cisco 15310-MA Průvodce řešením problémů Strana 323

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco 15310-MA