Cisco 15310-MA Průvodce řešením problémů Strana 189

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 380
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 188
2-59
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0
78-18394-01
Chapter 2 Alarm Troubleshooting
Alarm Procedures
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).
2.7.65 ERFI-P-PAYLD
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
SONET Logical Objects: STSMON, STSTRM
The Three-Bit ERFI Path Payload condition is triggered on DS-1, DS-3, or VT circuits when the
“PLM-P” alarm on page 2-122 alarm is raised on the transmission signal.
Clear the ERFI-P-PAYLD Condition
Step 1 Complete the “Clear the PLM-P Alarm” procedure on page 2-123. This should clear the ERFI condition.
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).
2.7.66 ERROR-CONFIG
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
The Error in Startup Configuration alarm applies to the ML-100T-8 Ethernet cards. These cards process
startup configuration files line by line. If one or more lines cannot be executed, the error causes the
ERROR-CONFIG alarm. ERROR-CONFIG is not caused by hardware failure.
The typical reasons for an errored startup file are:
The user stored the configuration for one type of ML-100T-8 Ethernet card in the database and then
installed another type in its slot.
The configuration file contained a syntax error.
Note For information about provisioning the ML-100T-8 Ethernet cards from the Cisco IOS interface, refer to
the Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration
Guide.
Clear the ERROR-CONFIG Alarm
Step 1 If the ML-100T-8 Ethernet configuration is different from the actual installation, create the correct
startup configuration based upon the installation.
Consult the ML-100T-8 POS provisioning parameters for the card and POS ports in the
Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide.
Zobrazit stránku 188
1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 379 380

Komentáře k této Příručce

Žádné komentáře