Cisco 15310-MA Průvodce řešením problémů stáhnout pdf (Strana 190)

2-60

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 2 Alarm Troubleshooting

Alarm Procedures

Step 2 Upload the configuration file to the controller card (15310-CL-CTX or CTX2500 card) by completing

the following steps:

a. In node view, right-click the ML-100T-8 Ethernet card graphic.

b. Choose IOS Startup Config from the shortcut menu.

c. Click Local > TCC and navigate to the file location in the Open dialog box.

Step 3 Complete the “Soft- or Hard-Reset an Ethernet or Electrical Card in CTC” procedure on page 2-162.

Caution Avoid soft-resetting multiple ONS 15310-MA cards at one time; doing so might cause an unexpected

traffic hit.

Step 4 If the alarm does not clear or if your configuration file was correct according to the installed card, start

a Cisco IOS CLI for the card by completing the following steps:

a. Right-click the ML-100T-8 Ethernet card graphic in node view.

b. Choose Open IOS Connection from the shortcut menu.

Note “Open IOS Connection” is not available unless the ML-100T-8 Ethernet card is physically

installed in the shelf.

Follow the card provisioning instructions in the Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet

Card Software Feature and Configuration Guide to correct the errored configuration file line.

Step 5 Execute the following CLI command:

copy run start

The command copies the new card configuration into the database and clears the alarm.

Step 6 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport

for more information or call Cisco TAC (1-800-553-2447).

2.7.67 ETH-LINKLOSS

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

SONET Logical Object: NE

The Rear Panel Ethernet Link Removed condition, if enabled in the network defaults, is raised under the

following conditions:

• The node.network.general.AlarmMissingBackplaneLAN field in NE default is enabled.

• The node is configured as a gateway network element (GNE).

• The LAN cable is removed.

For more information about Ethernet operation in the ONS 15310-CL or ONS 15310-MA, refer to the

Cisco ONS 15310-CL and Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration

Guide.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 379 380

Žádné komentáře

Cisco 15310-MA Průvodce řešením problémů Strana 190