Cisco 15310-MA Průvodce řešením problémů stáhnout pdf (Strana 347)

4-39

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-5069 A source node cannot be added to either of these lists. Select a node other than the source node to

add to the route.

EID-5070 A destination node cannot be added to either of these lists. Select a node other than the destination

node to add to the route.

EID-5071 This node already belongs to one of these lists. The node is already selected either in

include or exclude list in the OCH circuit.

EID-5072 An OCH-Trail tunnel link was found but without any associated

circuit.

Create an OCH-Trail circuit associated with

the link.

EID-5073 You are creating an unprotected link from a protected port.

Do you want to continue?

Refer to the error message.

EID-5074 Deleting OCH DCN circuits will cause a loss of connectivity to

nodes in the circuit path that do not have other DCN

connections.

Do you want to continue?

Refer to the error message.

EID-5075 The VLAN ID must be a number between 1 and 4093. Enter a number between 1 and 4093.

EID-5076 An error occurred while provisioning the VLAN ID.

The VLAN ID is already present in the current profile

Select a VLAN ID that is not present in the

current profile.

EID-5077 An error occurred while provisioning the VLAN database

profile.

{0}

CTC could not save the VLAN profile to the

file name mentioned.

EID-5078 The VLAN merge is not complete.

You forgot to fill {0} record(s).

Fill in the number of records specified and

then proceed.

EID-5079 An error occurred while validating the provisionable patchcord. Refer to the error message text.

EID-5080 No rolls are available. You cannot delete a roll without selecting a

roll.

EID-5081 An error occurred while tracing the RPR ring:

{0}

The circuit reference is invalid.

EID-5082 {0} does not support:

- Low-order circuits that have both {1}-protected and

{2}-protected spans and that cross a node that does not have

low-order cross-connect capability.

- High-order circuits that carry low-order circuits with the

parameters described above.

Refer to the error message text.

EID-5083 This circuit is not the same size as the existing circuit {0}.

This circuit has size {1} and the existing circuit has size {2}.

During an RPR circuit creation ML card,

the new circuit size and the existing circuit

size must be the same.

EID-5084 The Trunk model could not be found.

{0}

The trunk specified is not found.

EID-5085 The maximum number of VLAN DB profiles is {0}. Refer to the error message.

EID-5086 The circuit roll failed.

You cannot bridge and roll the selected circuit because it has a

monitor circuit.

Refer to the error message.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 379 380

Komentáře k této Příručce

Žádné komentáře

Cisco 15310-MA Průvodce řešením problémů Strana 347

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco 15310-MA