Cisco 15310-MA Průvodce řešením problémů stáhnout pdf (Strana 356)

4-48

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-6124 The ALS recovery pulse interval is invalid. Refer to the error message text.

EID-6125 The ALS recovery pulse duration is invalid. Refer to the error message text.

EID-6126 The current setting does not support the specified ALS mode. Refer to the error message text.

EID-6127 All enabled routers are required to have the same area. Refer to the error message text.

EID-6128 A software download is in progress. Configuration changes that

result in a card reboot cannot take place during a software

download.

Please try again after the software download is done.

Refer to the error message text.

EID-6129 The payload configuration and card mode are incompatible. Refer to the error message text.

EID-6135 A DCC is present. A data communication channel (DCC)

already exists.

EID-6136 An error occurred during provisioning: {0} CTC was not able to provision the specified

port or card.

EID-6137 Multishelf cannot be disabled.

{0}

Multishelf is not supported on equipment, is

already disabled, or modules on the shelf

are currently in use.

EID-6138 The LAN configuration is invalid. Verify the LAN configuration.

EID-6139 Invalid card(s) are present.

Please remove all non-MSTP cards and try again.

Non-DWDM cards cannot be added to an a

DWDM node. Remove the cards.

EID-6140 The shelf identifier for a subtended shelf cannot be provisioned

through CTC. It must be changed using the LCD.

Refer to the error message text.

EID-6143 The DHCP server could not be changed. Refer to the error message text.

EID-6144 The port provisioning cannot be changed when the port media

is Undefined.

If the port is not pre-provisioned with the

type of media that is going to be inserted,

you cannot access any of the existing values

for the port.

WID-6145 OSPF on LAN should only be enabled when the LAN routers

run OSPF. Otherwise, the node will not be reachable from

outside its subnet.

RIP implementation only advertise routes in one direction to

connected routers. It does not learn or distribute routes

advertised by other routers.

Also note that enabling OSPF on the LAN will temporarily

cause the current list of static routes to stop being advertised to

remote nodes and only be used locally.

Refer to the warning message text.

WID-6146 Deleting the protection group while in a switched state might

cause a loss of traffic. It is recommended that you verify switch

states before proceeding.

Refer to the warning message text.

EID-6149 The LAPD MTU size must be greater than or equal to the {0}

LSP buffer size {1}. Alternatively, you can decrease the {0}

LSP buffer size to {2}.

Refer to the error message text.

EID-6150 The value is out of range. Enter a value that is within the range.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 351 352 353 354 355 356 357 358 359 360 361 ... 379 380

Komentáře k této Příručce

Žádné komentáře

Cisco 15310-MA Průvodce řešením problémů Strana 356

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco 15310-MA