Cisco Cisco Access Registrar 4.2 Specifikace Strana 69

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 636
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 68
3-11
Cisco Wireless LAN Controller Configuration Guide
OL-13826-01
Chapter 3 Configuring Ports and Interfaces
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
This page shows the current controller interface settings.
Step 2 If you want to modify the settings of a particular interface, click the name of the interface. The Interfaces
> Edit page for that interface appears.
Step 3 Configure the following parameters for each interface type:
Management Interface
Note The management interface uses the controller’s factory-set distribution system MAC address.
VLAN identifier
Note Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
that only tagged VLANs be used on the controller.
Fixed IP address, IP netmask, and default gateway
Physical port assignment
Primary and secondary DHCP servers
Access control list (ACL) setting, if required
Note To create ACLs, follow the instructions in Chapter 5.
AP-Manager Interface
VLAN identifier
Note Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
that only tagged VLANs be used on the controller.
Fixed IP address, IP netmask, and default gateway
Note The AP-manager interface’s IP address must be different from the management interface’s
IP address and may or may not be on the same subnet as the management interface. However,
Cisco recommends that both interfaces be on the same subnet for optimum access point
association.
Physical port assignment
Primary and secondary DHCP servers
Access control list (ACL) name, if required
Note To create ACLs, follow the instructions in Chapter 5.
Zobrazit stránku 68
1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 635 636

Komentáře k této Příručce

Žádné komentáře