Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 326)

100

101

7-16

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 7 Controlling Lightweight Access Points

Cisco Aironet 1510 Series Lightweight Outdoor Mesh Access Points

Step 3 Click Apply to commit your changes.

Step 4 Click Save Configuration to save your changes.

Using the CLI to Configure Mesh Parameters

Follow these steps to configure global mesh parameters using the controller CLI.

Note Refer to the “Using the GUI to Configure Mesh Parameters” section on page 7-14 for descriptions, valid

ranges, and default values of the parameters used in the CLI commands.

Step 1 To specify the maximum range (in feet) of all access points in the network, enter this command:

config mesh range feet

To see the current range, enter show mesh range.

Step 2 To enable or disable the MAC filter list, enter this command:

config mesh mac-filter {enable | disable}

Step 3 To enable or disable client association on the primary backhaul (802.11a) of an access point, enter these

commands:

• config mesh client-access {enable | disable}

• config ap wlan {enable | disable} 802.11a Cisco_AP

• config ap wlan {add | delete} 802.11a wlan_id Cisco_AP

Step 4 To define the security mode, enter this command:

config mesh security {eap | psk}

Step 5 To save your changes, enter this command:

save config

Using the CLI to View Mesh Parameters

Use these commands to obtain information on mesh access points:

• show Cisco_AP—Shows the mesh configuration for the specified access point.

• show mesh client-access —Shows the status of the client-access backhaul as either enabled or

disabled. When this option is enabled, mesh access points are able to associate with 802.11a wireless

clients over the 802.11a backhaul. This client association is in addition to the existing

communication on the 802.11a backhaul between the root and mesh access points.

• show mesh env {summary | Cisco_AP}—Shows the temperature, heater status, and Ethernet status

for either all access points (summary) or a specific access point (Cisco_AP). The access point name,

role (RootAP or MeshAP), and model are also shown.

–

The temperature is shown in both Fahrenheit and Celsius.

–

The heater status is ON or OFF.

–

The Ethernet status is UP or DOWN.

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 326

Komentáře k této Příručce