Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 470)

100

101

10-28

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 10 Configuring Radio Resource ManagementWireless Device Access

Overriding Dynamic RRM

Disabling Dynamic Channel and Power Assignment Globally for a Controller

This section provides instructions for disabling dynamic channel and power assignment using the GUI

or CLI.

Using the GUI to Disable Dynamic Channel and Power Assignment

Follow these steps to configure disable dynamic channel and power assignment using the GUI.

Step 1 Click Wireless > 802.11a/n or 802.11b/g/n > RRM > Auto RF to open the 802.11a (or 802.11b/g)

Global Parameters > Auto RF page (see Figure 10-2).

Step 2 To disable dynamic channel assignment, choose Off under RF Channel Assignment.

Step 3 To disable dynamic power assignment, choose Fixed under Tx Power Level Assignment and choose a

default transmit power level from the drop-down box.

Note See Step 4 on page 10-26 for information on transmit power levels.

Step 4 Click Apply to commit your changes.

Step 5 Click Save Configuration to save your changes.

Step 6 If you are overriding the default channel and power settings on a per radio basis, assign static channel

and power settings to each of the access point radios that are joined to the controller.

Step 7 If desired, repeat this procedure for the network type you did not select (802.11a or 802.11b/g).

Using the CLI to Disable Dynamic Channel and Power Assignment

Follow these steps to disable RRM for all 802.11a or 802.11b/g radios.

Step 1 Enter this command to disable the 802.11a or 802.11b/g network:

config {802.11a | 802.11b} disable

Step 2 Enter this command to disable RRM for all 802.11a or 802.11b/g radios and set all channels to the

default value:

config {802.11a | 802.11b} channel global off

Step 3 Enter this command to enable the 802.11a or 802.11b/g network:

config {802.11a | 802.11b} enable

Note To enable the 802.11g network, enter config 802.11b 11gSupport enable after the config

802.11b enable command.

Step 4 Enter this command to save your settings:

save config

1 2 ... 465 466 467 468 469 470 471 472 473 474 475 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 470

Komentáře k této Příručce