
10-29
Cisco Wireless LAN Controller Configuration Guide
OL-13826-01
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Viewing Additional RRM Settings Using the CLI
Viewing Additional RRM Settings Using the CLI
Use these commands to view additional 802.11a and 802.11b/g RRM settings:
• show advanced 802.11a ?
• show advanced 802.11b ?
where ? is one of the following:
ccx—Shows the Cisco Compatible Extensions (CCX) RRM configuration.
channel—Shows the channel assignment configuration and statistics.
logging—Shows the RF event and performance logging.
monitor—Shows the Cisco radio monitoring.
profile—Shows the access point performance profiles.
receiver—Shows the 802.11a or 802.11b/g receiver configuration and statistics.
summary—Shows the configuration and statistics of the 802.11a or 802.11b/g access points
txpower—Shows the transmit power assignment configuration and statistics.
Note To troubleshoot RRM-related issues, refer to the Cisco Wireless LAN Controller Command Reference,
Release 3.2 for RRM (airewave-director) debug commands.
Configuring CCX Radio Management Features
You can configure two parameters that affect client location calculations:
• Radio measurement requests
• Location calibration
These parameters are supported in Cisco Client Extensions (CCX) v2 and higher and are designed to
enhance location accuracy and timeliness for participating CCX clients. See the “Configuring Cisco
Client Extensions” section on page 6-35 for more information on CCX.
For the location features to operate properly, the access points must be configured for normal, monitor,
or hybrid-REAP mode. However, for hybrid-REAP mode, the access point must be connected to the
controller.
Note CCX is not supported on the AP1030.
Komentáře k této Příručce