Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 182)

100

101

4-84

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 4 Configuring Controller SettingsWireless Device Access

Configuring the Supervisor 720 to Support the WiSM

Configuring the Supervisor

Log into the switch or router CLI and, beginning in Privileged Exec mode, follow these steps to

configure the supervisor to support the WiSM:

Note The commands used for communication between the Cisco WiSM, the Supervisor 720, and the 4404

controllers are documented in Configuring a Cisco Wireless Services Module and Wireless Control

System at this URL:

http://www.cisco.com/en/US/docs/wireless/technology/wism/technical/reference/appnote.html#wp394

Command Purpose

Step 1

configure terminal Enter global configuration mode.

Step 2

interface vlan Create a VLAN to communicate with the data ports on the WiSM

and enter interface config mode.

Step 3

ip address ip-address gateway Assign an IP address and gateway to the VLAN.

Step 4

ip helper-address ip-address Assign a helper address to the VLAN.

Step 5

end Return to global config mode.

Step 6

wism module module_number

controller { 1 | 2}

allowed-vlan vlan_number

Create Gigabit port-channel interfaces automatically for the

specified WiSM controller and configure the port-channel

interfaces as trunk ports. Also, specify the VLAN you created

earlier as the allowed VLAN on the port-channel trunk. VLAN

traffic is carried on the trunk between the WiSM controller and

the supervisor.

Note Services might be temporarily interrupted (for

approximately two pings) after you enter this command.

Step 7

wism module module_number

controller { 1 | 2}

native-vlan vlan_number

For the native VLAN on the ports, specify the VLAN that you

created earlier to communicate with the WiSM data ports.

Step 8

interface vlan Create a VLAN to communicate with the service ports on the

WiSM.

Step 9

ip address ip_address gateway Assign an IP address and gateway to the VLAN.

Step 10

end Return to global config mode.

Step 11

wism service-vlan vlan Configure the VLAN that you created in steps 8 through 10 to

communicate with the WiSM service ports.

Step 12

end Return to global config mode.

Step 13

show wism status Verify that the WiSM is operational.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 182

Komentáře k této Příručce