Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 361)

100

101

7-51

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 7 Controlling Lightweight Access Points

Cisco Workgroup Bridges

Note The controller supports only Cisco WGB products. Linksys and OEM WGB devices are not

supported. Although the Cisco Wireless Unified Solution does not support the Linksys

WET54G and WET11B Ethernet Bridges, you can use these devices in a Wireless Unified

Solution configuration if you follow these guidelines:

1. Connect only one device to the WET54G or WET11B.

2. Enable the MAC cloning feature on the WET54G or WET11B to clone the connected

device.

3. Install the latest drivers and firmware on devices connected to the WET54G or WET11B.

This guideline is especially important for JetDirect printers because early firmware versions

might cause problems with DHCP.

Note: Because these devices are not supported in the Cisco Wireless Unified Solution, Cisco

Technical Support cannot help you troubleshoot any problems associated with them.

Perform one of the following to enable the workgroup bridge mode on the WGB:

–

On the WGB access point GUI, choose Workgroup Bridge for the role in radio network on the

Settings > Network Interfaces page.

–

On the WGB access point CLI, enter this command: station-role workgroup-bridge

Note See the sample WGB access point configuration in the “Sample WGB Configuration”

section on page 7-52.

• The WGB can associate only to lightweight access points (except the Cisco Airespace AP1000

series access points, which are not supported).

• Only WGBs in client mode (which is the default value) are supported. Those in infrastructure mode

are not supported. Perform one of the following to enable client mode on the WGB:

–

On the WGB access point GUI, choose Disabled for the Reliable Multicast to WGB parameter.

–

On the WGB access point CLI, enter this command: no infrastructure client.

Note VLANs are not supported for use with WGBs.

Note See the sample WGB access point configuration in the “Sample WGB Configuration”

section on page 7-52.

• These features are supported for use with a WGB:

–

Guest N+1 redundancy

–

Local EAP

–

Open, WEP 40, WEP 128, CKIP, WPA+TKIP, WPA2+AES, LEAP, EAP-FAST, and EAP-TLS

authentication modes

• These features are not supported for use with a WGB:

–

Cisco Centralized Key Management (CCKM)

–

Hybrid REAP

1 2 ... 356 357 358 359 360 361 362 363 364 365 366 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 361

Komentáře k této Příručce