Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 304)

100

101

6-40

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 6 Configuring WLANsWireless Device Access

Configuring WLANs

To configure access point groups, follow these top-level steps:

1. Configure the appropriate dynamic interfaces and map them to the desired VLANs.

For example, to implement the network in Figure 6-16, create dynamic interfaces for VLANs 61,

62, and 63 on the controller. Refer to Chapter 3 for more information about how to configure

dynamic interfaces.

2. Create the access point groups. Refer to the “Creating Access Point Groups” section on page 6-40.

3. Assign access points to the appropriate access point group. Refer to the “Assigning Access Points

to Access Point Groups” section on page 6-42.

Creating Access Point Groups

Once all access points have joined the controller, you can create access point groups and assign each

group to one or more WLANs. You also need to define WLAN-to-interface mapping.

Note You can create up to 150 access point groups on the controller.

Using the GUI to Create Access Point Groups

Follow these steps to create an access point group using the controller GUI.

Step 1 Click WLANs > Advanced > AP Groups VLAN to open the AP Groups VLAN page (see Figure 6-17).

Figure 6-17 AP Groups VLAN Page

Step 2

Check the AP Groups VLAN Feature Enable check box to enable this feature. The default value is

unchecked.

Step 3 Enter the group’s name in the AP Group Name field.

Step 4 Enter the group’s description in the AP Group Description field.

Step 5 Click Create New AP-Group to create the group. The newly created access point group appears in the

middle of the page.

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 304

Komentáře k této Příručce