Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 329)

100

101

7-19

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 7 Controlling Lightweight Access Points

Cisco Aironet 1510 Series Lightweight Outdoor Mesh Access Points

This page shows the following information:

• The bridge type, which specifies whether the access point is designed for indoor or outdoor use. This

field is set to Outdoor for the AP1510.

• The backhaul interface, or the radio band that this access point uses to transfer data to other

AP1510s. The only possible value is 802.11a.

Step 4 From the AP Role drop-down box, choose one of the following options to specify the role of this access

point in the mesh network:

• MeshAP—Choose this option if the AP1510 has a wireless connection to the controller. This is the

default setting.

• RootAP—Choose this option if the AP1510 has a wired connection to the controller.

Note If you upgrade to software release 4.2 from a previous release, your root access points default to

the MeshAP role. You must reconfigure them for the RootAP role.

Note You must set the root access point to RootAP. Otherwise, a mesh network is not created.

Step 5 To assign this AP1510 to a bridge group, enter a name for the group in the Bridge Group Name field.

Step 6 Check the Ethernet Bridging check box if you want to enable Ethernet bridging on the access point.

Otherwise, uncheck this check box. The default setting is disabled (or unchecked).

Note You must enable bridging on all access points for which you want to allow bridging, including

the RAP. Therefore, if you want to allow an Ethernet on a MAP to bridge to the RAP’s Ethernet,

you must enable bridging on the RAP as well as the MAP.

Step 7 From the Bridge Data Rate drop-down box, choose a value (in Mbps) for the rate at which data is shared

between access points on the backhaul interface. The default value is 18 Mbps for the 802.11a backhaul

interface.

Step 8 Click Apply to commit your changes.

Step 9 Click Save Configuration to save your changes.

Using the CLI to Configure Bridging Parameters

Follow these steps to configure bridging parameters using the controller CLI.

Step 1 To specify that your AP1510 has bridge functionality, enter this command:

config ap mode bridge Cisco_AP

Step 2 To specify the role of this access point in the mesh network, enter this command:

config ap role {rootAP | meshAP} Cisco_AP

Use the meshAP parameter if the AP1510 has a wireless connection to the controller (this is the default

setting in software release 4.0 or later), or use the rootAP parameter if the AP1510 has a wired

connection to the controller.

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 329

Komentáře k této Příručce