Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 301)

100

101

6-37

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 6 Configuring WLANsWireless Device Access

Configuring WLANs

Step 3 Click Back to return to the previous screen.

Step 4 Repeat this procedure to view the CCX version supported by any other client devices.

Using the CLI to Configure CCX Aironet IEs

To enable or disable support for Aironet IEs for a particular WLAN, enter this command:

config wlan ccx aironet-ie {enable | disable} wlan_id

The default value is enabled.

Using the CLI to View a Client’s CCX Version

To see the CCX version supported by a particular client device, enter this command:

show client detail mac-addr

Configuring WLAN Override

By default, access points transmit all defined WLANs on the controller. However, you can use the

WLAN override option to select which WLANs are transmitted and which are not on a per access point

basis. For example, you can use WLAN override to control where in the network the guest WLAN is

transmitted, or you can use it to disable a specific WLAN in a certain area of the network.

Using the GUI to Configure WLAN Override

Follow these steps to configure the WLAN override option for a specific access point.

Step 1 Click Wireless > Access Points > Radios > 802.11a/n or 802.11b/g/n to open the 802.11a/n (or

802.11b/g/n) Radios page.

Step 2 Hover your cursor over the blue drop-down arrow for the desired access point and choose Configure.

The 802.11a/n (or 802.11b/g/n) Cisco APs > Configure page appears (see Figure 6-15).

Figure 6-15 802.11a/n Cisco APs > Configure Page

Step 3

Choose Enable from the WLAN Override drop-down box to enable the WLAN override feature for this

access point or choose Disable to disable this feature.

1 2 ... 296 297 298 299 300 301 302 303 304 305 306 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 301

Komentáře k této Příručce