Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 385)

100

101

7-75

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 7 Controlling Lightweight Access Points

Viewing Clients

You can use the controller GUI or CLI to view information about the clients that are associated to the

controller’s access points.

Using the GUI to View Clients

Using the GUI, follow these steps to view client information.

Step 1 Click Monitor > Clients to open the Clients page (see Figure 7-35).

Figure 7-35 Clients Page

This page lists all of the clients that are associated to the controller’s access points. It provides the

following information for each client:

• The MAC address of the client

• The name of the access point to which the client is associated

• The name of the WLAN used by the client

• The type of client (802.11a, 802.11b, 802.11g, or 802.11n)

Note If the 802.11n client associates to an 802.11a radio that has 802.11n enabled, then the client

type shows as 802.11n(5). If the 802.11n client associates to an 802.11b/g radio with

802.11n enabled, then the client type shows as 802.11n (2.4).

• The status of the client connection

• The authorization status of the client

• The port number of the access point to which the client is associated

• An indication of whether the client is a WGB

Note Refer to the “Cisco Workgroup Bridges” section on page 7-49 for more information on the

WGB status.

1 2 ... 380 381 382 383 384 385 386 387 388 389 390 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 385

Komentáře k této Příručce