Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 576)

100

101

D-4

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Appendix D Troubleshooting

System Messages

ROGUE_AP_REMOVED Detected rogue access point has timed out. The

unit might have shut down or moved out of the

coverage area.

AP_MAX_ROGUE_COUNT_EXCEEDED The current number of active rogue access points

has exceeded system threshold.

LINK_UP Positive confirmation message.

LINK_DOWN Port may have a problem or is administratively

disabled.

LINK_FAILURE Port may have a problem or is administratively

disabled.

AUTHENTICATION_FAILURE Attempted security breech. Investigate.

STP_NEWROOT Informational message.

STP_TOPOLOGY_CHANGE Informational message.

IPSEC_ESP_AUTH_FAILURE Check WLAN IPSec configuration.

IPSEC_ESP_REPLAY_FAILURE Check for attempt to spoof IP Address.

IPSEC_ESP_POLICY_FAILURE Check for IPSec configuration mismatch between

WLAN and client.

IPSEC_ESP_INVALID_SPI Informational message.

IPSEC_OTHER_POLICY_FAILURE Check for IPSec configuration mismatch between

WLAN and client.

IPSEC_IKE_NEG_FAILURE Check for IPSec IKE configuration mismatch

between WLAN and client.

IPSEC_SUITE_NEG_FAILURE Check for IPSec IKE configuration mismatch

between WLAN and client.

IPSEC_INVALID_COOKIE Informational message.

RADIOS_EXCEEDED Maximum number of supported Cisco Radios

exceeded. Check for controller failure in the same

Layer 2 network or add another controller.

SENSED_TEMPERATURE_HIGH Check fan, air conditioning and/or other cooling

arrangements.

SENSED_TEMPERATURE_LOW Check room temperature and/or other reasons for

low temperature.

TEMPERATURE_SENSOR_FAILURE Replace temperature sensor ASAP.

TEMPERATURE_SENSOR_CLEAR Temperature sensor is operational.

POE_CONTROLLER_FAILURE Check ports — possible serious failure detected.

MAX_ROGUE_COUNT_EXCEEDED The current number of active rogue access points

has exceeded system threshold.

SWITCH_UP Controller is responding to SNMP polls.

SWITCH_DOWN Controller is not responding to SNMP polls, check

controller and SNMP settings.

Table D-1 System Messages and Descriptions (continued)

Error Message Description

1 2 ... 571 572 573 574 575 576 577 578 579 580 581 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 576

Komentáře k této Příručce