Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 587)

100

101

D-15

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Appendix D Troubleshooting

Troubleshooting CCXv5 Client Devices

Step 6 To send a request to the client to perform the DNS name resolution test to the specified host name, enter

this command:

config client ccx dns-resolve client_mac_address host_name

Note This test does not require the client to use the diagnostic channel.

Step 7 To send a request to the client to perform the association test, enter this command:

config client ccx test-association client_mac_address ssid bssid {802.11a | 802.11b | 802.11g} channel

Step 8 To send a request to the client to perform the 802.1X test, enter this command:

config client ccx test-dot1x client_mac_address profile_id bssid {802.11a | 802.11b | 802.11g} channel

Step 9 To send a request to the client to perform the profile redirect test, enter this command:

config client ccx test-profile client_mac_address profile_id

The profile_id should be from one of the client profiles for which client reporting is enabled.

Note Users are redirected back to the parent WLAN, not to any other profile. The only profile shown

is the user’s parent profile. Note however that parent WLAN profiles can have one child

diagnostic WLAN.

Step 10 Use these commands if necessary to abort or clear a test:

• To send a request to the client to abort the current test, enter this command:

config client ccx test-abort client_mac_address

Only one test can be pending at a time, so this command aborts the current pending test.

• To clear the test results on the controller, enter this command:

config client ccx clear-results client_mac_address

Step 11 To send a message to the client, enter this command:

config client ccx send-message client_mac_address message_id

where message_id is one of the following:

• 1 = The SSID is invalid.

• 2 = The network settings are invalid.

• 3 = There is a WLAN credibility mismatch.

• 4 = The user credentials are incorrect.

• 5 = Please call support.

• 6 = The problem is resolved.

• 7 = The problem has not been resolved.

• 8 = Please try again later.

• 9 = Please correct the indicated problem.

• 10 = Troubleshooting is refused by the network.

• 11 = Retrieving client reports.

• 12 = Retrieving client logs.

1 2 ... 582 583 584 585 586 587 588 589 590 591 592 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 587

Komentáře k této Příručce