Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 453)

100

101

10-11

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 10 Configuring Radio Resource ManagementWireless Device Access

Enabling Rogue Access Point Detection

After you have created an RF group of controllers, you need to configure the access points connected to

the controllers to detect rogue access points. The access points will then check the beacon/

probe-response frames in neighboring access point messages to see if they contain an authentication

information element (IE) that matches that of the RF group. If the check is successful, the frames are

authenticated. Otherwise, the authorized access point reports the neighboring access point as a rogue,

records its BSSID in a rogue table, and sends the table to the controller.

Using the GUI to Enable Rogue Access Point Detection

Follow these steps to enable rogue access point detection using the GUI.

Step 1 Make sure that each controller in the RF group has been configured with the same RF group name.

Note The name is used to verify the authentication IE in all beacon frames. If the controllers have

different names, false alarms will occur.

Step 2 Click Wireless to open the All APs page (see Figure 10-3).

Figure 10-3 All APs Page

Step 3

Click the name of an access point to open the All APs > Details page (see Figure 10-4).

1 2 ... 448 449 450 451 452 453 454 455 456 457 458 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 453

Komentáře k této Příručce