Cisco Cisco Access Registrar 4.2 Specifikace Strana 456

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 636
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 455
10-14
Cisco Wireless LAN Controller Configuration Guide
OL-13826-01
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Configuring Dynamic RRM
Using the CLI to Enable Rogue Access Point Detection
Follow these steps to enable rogue access point detection using the CLI.
Step 1 Make sure that each controller in the RF group has been configured with the same RF group name.
Note The name is used to verify the authentication IE in all beacon frames. If the controllers have
different names, false alarms will occur.
Step 2 Enter config ap mode local Cisco_AP or config ap mode monitor Cisco_AP to configure this particular
access point for local (normal) mode or monitor (listen-only) mode.
Step 3 Enter save config to save your settings.
Step 4 Repeat Step 2 and Step 3 for every access point connected to the controller.
Step 5 Enter config wps ap-authentication to enable rogue access point detection.
Step 6 Enter config wps ap-authentication threshold to specify when a rogue access point alarm is generated.
An alarm occurs when the threshold value (which specifies the number of access point frames with an
invalid authentication IE) is met or exceeded within the detection period.
Note The valid threshold range is from1 to 255, and the default threshold value is 1. To avoid false
alarms, you may want to set the threshold to a higher value.
Step 7 Enter save config to save your settings.
Step 8 Repeat Step 5 through Step 7 on every controller in the RF group.
Note If rogue access point detection is not enabled on every controller in the RF group, the access
points on the controllers with this feature disabled are reported as rogues.
Configuring Dynamic RRM
The controller’s preconfigured RRM settings are optimized for most deployments. However, you can
modify the controller’s dynamic RRM configuration parameters at any time through either the GUI or
the CLI.
Note You can configure these parameters on controllers that are part of an RF group or on controllers that are
not part of an RF group.
Note The RRM parameters should be set to the same values on every controller in an RF group. The RF group
leader can change at any time. If the RRM parameters are not identical for all RF group members,
varying results can occur when the group leader changes.
Zobrazit stránku 455
1 2 ... 451 452 453 454 455 456 457 458 459 460 461 ... 635 636

Komentáře k této Příručce

Žádné komentáře