Cisco Cisco Access Registrar 4.2 Specifikace stáhnout pdf (Strana 522)

100

101

12-14

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 12 Configuring Hybrid REAPWireless Device Access

Configuring Hybrid REAP

Figure 12-8 All APs > Access Point Name > VLAN Mappings Page

Step 11

Enter the number of the VLAN from which the clients will get an IP address when doing local switching

(VLAN 101, in this example) in the VLAN ID field.

Step 12 Click Apply to commit your changes.

Step 13 Click Save Configuration to save your changes.

Step 14 Repeat this procedure for any additional access points that need to be configured for hybrid REAP at the

remote site.

Using the CLI to Configure an Access Point for Hybrid REAP

Use these commands on the controller to configure an access point for hybrid REAP:

• config ap mode h-reap Cisco_AP—Enables hybrid REAP for this access point.

• config ap h-reap radius auth set {primary | secondary} ip_address auth_port secret

Cisco_AP—Configures a primary or secondary RADIUS server for a specific hybrid-REAP access

point.

Note Only the Session Timeout RADIUS attribute is supported in standalone mode. All other

attributes as well as RADIUS accounting are not supported.

Note To delete a RADIUS server that is configured for a hybrid-REAP access point, enter this

command: config ap h-reap radius auth delete {primary | secondary} Cisco_AP

• config ap h-reap vlan wlan wlan_id vlan-id Cisco_AP—Enables you to assign a VLAN ID to this

hybrid-REAP access point. By default, the access point inherits the VLAN ID associated to the

WLAN.

• config ap h-reap vlan {enable | disable} Cisco_AP—Enables or disables VLAN tagging for this

hybrid-REAP access point. By default, VLAN tagging is not enabled. Once VLAN tagging is

enabled on the hybrid-REAP access point, WLANs enabled for local switching inherit the VLAN

assigned at the controller.

1 2 ... 517 518 519 520 521 522 523 524 525 526 527 ... 635 636

Komentáře k této Příručce

Žádné komentáře

Cisco Cisco Access Registrar 4.2 Specifikace Strana 522

Komentáře k této Příručce