Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Uživatelský manuál Strana 86

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 398
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 85
532
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: The symptom is observed on a Cisco 7200 series, Cisco 7301, and Cisco 7500 series
that run Cisco IOS Release 12.4(10) or Release 12.4(12) and occurs only when a flash card is
accessed from the ROMmon prompt.
Workaround: There is no workaround. Note that the symptom does not occur in Release 12.4(8a) or
an earlier release.
CSCsh54161
Symptoms: Under certain unusual circumstances, routes can go SIA in an EIGRP network and create
transient routing loops.
Conditions: When the metric on an interface increases rapidly, the symptom can occur. This can
happen with MANET interfaces as well as bundled interfaces (such as port-channels).
Workaround: There is no workaround.
CSCsl01427
Symptoms: The following symptoms all relate to the same root cause:
1. In syntax check mode, if there is a standby in SSO mode, the cts dot1x command does not work
and the following error messages are displayed:
RouterRP(syntax-if)#cts dot1x %ERROR: Standby doesn’t support this command ^ %
Invalid input detected at ’^’ marker.
RouterRP(syntax-archive)#path disk0: %ERROR: Standby doesn’t support this command ^
% Invalid input detected at ’^’ marker.
2. After a redundancy force-switchover, the applet configuration is lost and retains only the applet
name. (This is done by configuring an applet on the main RP and switchover to the Standby by
issuing a redundancy force-switchover. Issue the sh run command on the Standby which is now
the main RP.) All the action statements are lost.
3. The Standby switch reloads by itself after going into the event manager applet configuration
mode:
Config Sync: Line-by-Line sync verifying failure on command: event manager applet
cli-test-01 due to parser return error
4. The Standby switch may also reload upon removing the command event manager applet:
RouterRP(config)#event manager applet 1 EEM: Applet 1 is currently being modified
OR
RouterRP(config)#no event manager applet 1 EEM: Applet 1 is currently being
modified
Conditions: The symptoms are observed in syntax check mode, if there is a standby in SSO mode.
Workaround: There is no workaround.
CSCsl33908
Symptoms: The image name displayed in show version will be truncated to 64 characters if the
image name is more than that.
Conditions: It occurs in High Availability (HA) setup.
Workaround: There is no workaround.
CSCsl66427
Symptoms: Shortly after replacing FlexWAN, SNMP queue starts to fill and SNMP queue full error
message is printed:
%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full
Conditions: Occurs on a Cisco 7600 router running Cisco IOS Release 12.2(33)SRD1.
Zobrazit stránku 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 397 398

Komentáře k této Příručce

Žádné komentáře