Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Uživatelský manuál Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 398
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
464
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: There is no workaround.
CSCte00934
Symptoms: If configuration loss occurs after bootup due to ROMmon bug CSCsq77835, copying
startup-config running-config followed by the write memory command does not always fix the
problem.
Conditions: This symptom is seen with corruption of SLOTCACHE ROMmon variable reenter cwan
configuration-card type, controller and interface configuration write mem.
Workaround: OIR the CWAN card, reenter cwan configuration and write memory.
CSCte02089
Symptoms: IP DSCP is rewritten to 0 after disposition on PE.
Conditions: This symptom occurs when unconfiguring and adding a VRF back for packets exiting
out of an interface having ip vrf receive configured.
Workaround: There is no workaround.
CSCte03083
Symptoms: With queuing policy attached on MFR, removing “encapsulation frame- relay” on the
physical interface puts the interface in inconsistent state. “Encapsulation frame-relay” cannot be
reconfigured on the physical interface.
Conditions: This symptom is see when QoS is in place.
Workaround: There is no workaround.
CSCte10706
Symptoms: When you configure FRF.12 “frame-relay fragment 512 end-to-end” on the serial
interface, the router crashes.
Conditions: The symptom is observed when you configure FRF.12 “frame-relay fragment 512
end-to-end” on a CJ-PA.
Workaround: There is no workaround.
CSCte10790
Symptoms: A Cisco Catalyst 6500 series switch may unexpectedly reload due to bus error on the
switching processor when making access list entry config changes or when removing an entire
access-list.
Conditions: This bug fixes two related crashes. One in which the crash occurs when making ace
configuration changes and another when removing an entire ACL.
Details on the conditions to trigger the crash when making the ace configuration changes:
This can be reproduced in all the branches and the basic criteria reproducing this is we should have
ACE is greater than 13, and we should have the extended ACE that has destination IPADDR.
The issue is seen when we have more that three ACE which have the same source and destination
address and mask and we delete the ACE in sequence like:
no 110
no 120
no 130
Then try to add ACE which has the same source address and mask but no destination. The infinite
loop will result in crash.
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 397 398

Komentáře k této Příručce

Žádné komentáře