
678
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
oer-map BRANCH 20 match traffic-class access-list Optimize_Voice_Traffic set mode route control
set mode monitor fast set resolve mos priority 1 variance 30 set resolve delay priority 2 variance 30
set active-probe jitter 10.100.10.1 target-port 1025 codec g729a << set probe frequency 4
Workaround: The workaround is to set higher probe frequency (higher than 5)
• CSCsu32104
Symptoms: A PRE-3 that is running Cisco IOS Release 12.2(31)SB code may encounter a Redzone
overrun memory corruption crash.
Conditions: Unknown at this time.
Workaround: Turn off Auto IP SLA MPLS by entering the auto ip sla mpls reset command.
• CSCsu36836
Symptoms: TCL scripts and policies attempting to work with open files and sockets simultaneously
may not operate properly. One symptom is the vwait command may fail by reporting "would wait
forever".
Conditions: Occurs when a TCL script opens both a file and a client or server socket simultaneously.
Workaround: Open and close files and sockets separately. Avoid having them open simultaneously.
• CSCsu46871
Symptoms: Unable to attach service policy to VT when bandwidth is configured in class default.
Conditions: Occurs when DLFI over ATM is configured while trying to attach service policy to VT
when bandwidth is configured in class default.
Workaround: Configure bandwidth in user defined class and attach to VT.
• CSCsu55145
Symptoms: Router crashes due to critical software exception.
Conditions: Occurs on a Cisco ASR 1000 running Cisco IOS Release 12.2.
Workaround: There is no workaround.
• CSCsu62667
Symptoms: LSP ID change after stateful switchover (SSO) due to failure in signaling recovered
label switched path (LSP).
Conditions: Occurs following a SSO switchover.
Workaround: There is no workaround.
• CSCsu64323
Symptoms: The show vpdn history failure command should show the history of session failures
due to entering incorrect password, but it does not show any history.
Router#show vp hi fa % VPDN user failure table is empty
Conditions: The problem was seen with Cisco 7201 running Cisco IOS Release 12.2(33)SRC1. No
problem with Cisco IOS Release 12.4(4)XD9.
Workaround: There is no workaround.
• CSCsu67637
Symptoms: IPv6 address of loopback interface set as passive under Intermediate
System-to-Intermediate System (IS-IS) router process is not present in IS-IS database.
Komentáře k této Příručce