Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Uživatelský manuál Strana 274

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 398
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 273
720
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: Avoid configuration while "show" commands are being run on the router.
CSCsl51914
Symptoms: On Cisco 7600/SIP400 supporting MLP interfaces, "priority percent" does not work.
Conditions: The conditional police rate values won’t get updated:
1) Whenever a member link addition or deletion happens from the bundle.
2) When all the members of the multilink are down and come back.
3) SPA / LC online insertion and removal (OIR).
Workaround: Use priority and with absolute-value (explicit) policer.
CSCsl51945
Symptoms: The HSRP IPv6 config on the standby RP may lose its address, such that the
configuration on the standby RP appears as: standby 1 ipv6 :: The standby resets as well.
Conditions: This will occur if group is in init state while doing the configuration or changes its state
to init after applying the configuration. If you re-apply the command on the active RP without first
removing it, then a config sync error will occur and the standby RP will reload.
Workaround: There is no workaround.
CSCsl51956
Symptoms: Active supervisor may reload and fail-over to the standby supervisor while trying to
reset Service and Application Module for IP (SAMI) in that chassis.
Conditions: This happens only when SAMI line card is reset while upgrading the linecard image.
This crash will not happen if you reset the module after the upgrade is complete.
Workaround: Always reset the SAMI LC after the completing the upgrade.
CSCsl52092
Symptoms: Port channel interfaces in the DHCP snooping database are not read back correctly when
the database is refreshed. Either the interface is not recognized and the entry is ignored, or the entry
may be assigned to the correct or an incorrect port channel.
Conditions: Happens in any case when a port channel interface is found in a DHCP snooping
database, and the database is read in.
Workaround: Use an interface other than port-channel, or do not use the DHCP snooping database.
CSCsl52220
Symptoms: The snmp ifindex persist command is incorrectly enabled on some interfaces.
Conditions: This issue affects interfaces with similar interface descriptors. For example, if the
command is enabled on Ethernet 0/1, it will be enabled on Ethernet 0/10 to Ethernet 0/19.
Workaround: There is no workaround.
CSCsl52323
Symptoms: In a scale configuration environment, anything over MPLS (AToM) manager signals RF
bogus RF_DONE event.
Conditions: This can result in a high availability misbehavior.
Workaround: There is no workaround.
CSCsl52508
Symptoms: Keepalive tunnels for manual L2TP sessions fail to come up.
Zobrazit stránku 273
1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 397 398

Komentáře k této Příručce

Žádné komentáře