Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Uživatelský manuál Strana 189

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 398
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 188
635
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
CSCsi07687
Symptoms: Self ping to SVI fails when VLAN configurations are removed and reapplied.
Conditions: Occurs when an interface is deleted and added again.
Workaround: There is no workaround.
CSCsi88974
Symptoms: While configuring a mediation device (MD), if the MediationSrcInterface is set to
loopback interface, traffic will cause MALLOC failures.
Conditions: Problem is seen when traffic rate is equal to or greater than 8000 packets per second.
Workaround: Do not use loopback0 as MD source interface.
CSCsj78403
Symptoms: A router may crash when the clear ip /jointfilesconvert/422273/bgp command is entered.
Conditions: Occurs on devices running BGP and configured as a route reflector client with
conditional route injection configured.
Workaround: Unconfigure conditional route injection.
CSCsk49705
Symptoms: The ip nat inside source static network command does not have the <cr> option.
Conditions: This symptom is observed on a Cisco 7200 router that is loaded with Cisco IOS Release
12.4 or 12.4T.
Workaround: There is no workaround.
CSCsk94179
Symptom: Connectivity problems are observed for IPv6 client, which obtained IPv6 prefix via
DHCP for Virtual Access interface, due to incorrect static routes in the routing table for the assigned
IPv6 prefix.
Conditions: Occurs with IPv6 prefix delegation via DHCP, when client moves from one interface to
another.
Workaround: None
Further problem description: When IPv6 prefix delegation assigns a prefix for Virtual Access
interface, it creates a static route for the prefix in the routing table. When a client moves to a new
interface, old binding and the old routes are retained, which causes the problem.
CSCsl68327
Symptoms: Packets may be lost during rekey.
Conditions: Occurs because IPSec transit packets may trigger invalid SPI.
Workaround: There is no workaround.
CSCsl71704
Symptoms: A receive access control list (rACL) with large ACL is not applied on interface if is QoS
configured.
Conditions: Occurs when rACL with large ACL is applied on an interface. It consumes over 60% of
ternary content addressable memory (TCAM) space. If the rACL is applied a second interface with
QoS, the configuration fails without displaying an error message.
Workaround: There is no workaround.
CSCsm28287
Zobrazit stránku 188
1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 397 398

Komentáře k této Příručce

Žádné komentáře