
765
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: The symptom is observed when using adaptive clock through an MLPPP interface. The
same configuration with POS interfaces (instead of an MLPPP interface) will allow the adaptive
clock get to an ACQUIRED state.
Workaround: There is no workaround.
• CSCsm62033
Symptoms: L2TP session does not come up.
Conditions: Occurs when a Cisco router marks the Call Serial Number AVP in the ICRP as
mandatory. This causes a third-party router to reject it.
Workaround: There is no workaround.
• CSCsm62038
Symptoms: A Cisco 7300 with an NSE-100 crashes.
Conditions: This symptom is observed if you configure a hierarchical policy map with a SET
command in the second level. The "set" command is not supported in the second level policy in the
PXF.
Workaround: Do not configure SET in the second level of a hierarchical policy map.
Further Problem Description: Because it is not a supported configuration, the router will not accept
that configuration in the future.
• CSCsm62179
Symptoms: MPLS pseudowire ping for SVI Mode Ethernet over MPLS over GRE (EoMPLSoGRE)
may fail.
Conditions: The symptom is observed if EoMPLSoGRE is configured with SVI mode.
Workaround: There is no workaround.
• CSCsm62533
Symptoms: A Cisco 10000 series router may reload unexpectedly while applying service profiles to
sessions.
Conditions: This symptom is observed when applying services that contain QoS parameters. The
service that contains QoS must not be the first service that is applied. The router might display
tracebacks that show that the aaa_attr handle is retired.
Workaround: There is no workaround.
• CSCsm62748
Symptoms: Issue seen on ES20 Line cards with MPB configuration on Ethernet virtual connection
(EVC), Traffic on bridge domain is flooded and may be sent out on incorrect EVCs instead of being
dropped by the filtering code.
Conditions: Issue seen with MPB configuration on EVC, and it generally may be seen with VLAN
range encapsulation on the EVC.
Workaround: There is no workaround.
• CSCsm63632
Symptoms: Watermark and XDR error messages indicating a failure to create IPC buffers are seen,
such as:
%XDR-6-XDRIPCPEER: XDR IPC error occurred for peer in slot 3/0 (3) due to inability to
create an IPC buffer. %IPC-5-WATERMARK: 1123 messages pending in xmt for the port Slot
3: FAST.control.RIL(2030000.11) from source seat 2160000
Komentáře k této Příručce