Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Uživatelský manuál Strana 202

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 398
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 201
648
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Symptoms: VPDN redirect functionality does not work.
Conditions: Basic functionality is broken. No special condition is required.
Workaround: There is no workaround.
CSCsu46822
Symptoms: When account logon is done for a DHCP user, QoS policies defined in the user profile
are not applied to the ISG session.
Conditions: A DHCP session is created. User performs account logon via SESM (not CoA). User
profile has QoS polices defined. Session is authenticated but policies are not applied to the session.
Workaround: Perform account logon using CoA.
CSCsu46871
Symptoms: Unable to attach service policy to VT when bandwidth is configured in class default.
Conditions: Occurs when DLFI over ATM is configured while trying to attach service policy to VT
when bandwidth is configured in class default.
Workaround: Configure bandwidth in user defined class and attach to VT.
CSCsu47037
Symptoms: Router crashes when an attempt is made to forward a packet out of an Auto-Template
interface.
Conditions: This occurs when the interface’s MTU is set to 0: Use the show interface
Auto-Template X command to show the MTU.
Workaround: Configure a protocol MTU directly on the Auto-Template interface.
CSCsu48898
Symptoms: A Cisco 10000 series router may crash every several minutes.
Conditions: The symptom is observed with a Cisco 10000 series router that is running Cisco IOS
Release 12.2(31)SB13.
Workaround: Use Cisco IOS Release 12.2(31)SB11.
CSCsu50118
Symptoms: More convergence time seen even with the carrier-delay msec 0 command configured.
Conditions: Occurs when carrier-delay msec 0 is configured on a gigabit interface.
Workaround: If excessive convergence time is observed even with the carrier-delay msec 0
command configured, enter the command again on the interface.
CSCsu51095
Symptoms: If connected routes are optimized using PfR, there will be a routing loop.
Conditions: This symptom can occur if, for some reason, PfR is learning connected routes or if the
user has configured them.
Workaround: Create an oer-map with a prefix-list that contains the prefixes with the IP addresses of
the connected routes (the next hops). Set the set observe mode in the oer-map.
CSCsu51245
Symptoms: Port-channel QinQ subinterface on ESM20 and SIP600 line cards do not pass traffic
after router reload and line card reset.
Conditions: This condition is seen after router reload or member link line card reset. This is not seen
when configuration is newly applied.
Zobrazit stránku 201
1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 397 398

Komentáře k této Příručce

Žádné komentáře