Cisco PA-E3 Specifikace stáhnout pdf (Strana 67)

Configuring the PA-E3 Interfaces 8-21

Using the loopback Command to Verify the Physical Interface

• Set the interface into network payload loopback mode as follows:

Router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

router(config)# interface serial 10/0/0

router(config-if)# loopback network payload

Network payload loopback loops just the payload data back toward the network at the E3 framer.

1 2 ... 62 63 64 65 66 67 68

Žádné komentáře

Cisco PA-E3 Specifikace Strana 67