Cisco PA-E3 Specifikace stáhnout pdf (Strana 53)

Configuring the PA-E3 Interfaces 8-7

Performing a Basic Configuration

Slots in the Cisco 7140 series routers are numbered as shown Figure 8-6. The ﬁxed LAN interface

is slot 0, the ﬁxed WAN interfaces are slots 1 and 2, and the modular port adapter interface is slot 4.

Slot 3 is not used. Slot 5 is the service module.

Figure 8-6 Port Adapter Slot Numbering—Cisco 7140 Series

Performing a Basic Conﬁguration

The following steps are for a basic interface conﬁguration for the PA-E3. Press the Return key after

each step unless otherwise noted. At any time you can exit the privileged level and return to the user

level by entering disable at the prompt:

router# disable

router>

Step 1 At the privileged-level prompt, enter conﬁguration mode and specify that the console

terminal is the source of the conﬁguration subcommands:

router# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

router(config)#

Step 2 Specify the interface to conﬁgure:

• For Cisco 7100 series, Cisco 7200 series, or Cisco uBR7200 series routers, specify the

interface to conﬁgure by entering the subcommand interface serial followed by the

slot/port (port adapter slot number and interface port number). The example that

follows is for the interface of the port adapter in slot 3:

router(config)# interface serial 3/0

• For a VIP2, specify the interface to conﬁgure by entering the subcommand

interface serial, followed by the slot/port-adapter/port (interface processor slot

number, port adapter slot number, and interface port number). The example that

follows is for the interface of the ﬁrst port adapter on a VIP2 in interface processor slot

router(config)# interface serial 1/0/0

• For a Catalyst RSM/VIP2, specify the interface to conﬁgure by entering the

subcommand interface serial, followed by the port-adapter/port (port adapter slot

number and interface port number). The example that follows is for the interface of

the ﬁrst port adapter on a Catalyst RSM/VIP2:

router(config)# interface serial 0/0

SLOT 0 SLOT 1

AC OK

DC OK

OTF

AC OK

DC OK

OTF

155 - MM

CEL CAR ALM

155 - MM

CONS

FE 0 / 0 FE

ACT

0 / 1

AUX

7140 - 2MM3

CEL CAR ALM

ACT

LNK

PWR

SYS

RDY

ERROR

BOOT

RESETSM-EC-DS

18499

Slot 1 Slot 0 Slot 2

Slot 4Slot 5

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

Komentáře k této Příručce

Žádné komentáře

Cisco PA-E3 Specifikace Strana 53

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco PA-E3