Cisco 3002 - VPN Hardware Client Uživatelská příručka Strana 72

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 220
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 71
8 Management Protocols
8-4
VPN 3002 Hardware Client User Guide
Configuration | System | Management Protocols | Telnet
This screen lets you configure and enable the VPN 3002 Telnet terminal emulation server, and Telnet
over SSL (Secure Sockets Layer protocol). When the server is enabled, you can use a Telnet client to
communicate with the VPN 3002. You can fully manage and administer the VPN 3002 using the Cisco
Command Line Interface via Telnet.
Telnet server login usernames and passwords are the same as those enabled and configured on the
Administration | Access Rights | Administrators screens.
Telnet/SSL uses a secure, encrypted connection. This enabled by default for Telnet/SSL clients.
See the
Configuration | System | Management Protocols | SSL screen to configure SSL parameters. See the
Administration | Certificate Management | Certificates screen to manage the SSL digital certificate.
Figure 8-4: Configuration | System | Management Protocols | Telnet screen
Enable Telnet
Check the box to enable the Telnet server. The box is checked by default. Disabling the Telnet server
provides additional security, but doing so prevents using the Cisco Command Line Interface via Telnet.
Enable Telnet/SSL
Check the box to enable Telnet over SSL. The box is checked by default. Telnet/SSL uses Telnet over a
secure, encrypted connection.
Telnet Port
Enter the port number that the Telnet server uses. The default is 23, which is the well-known port
number.
Telnet/SSL Port
Enter the port number that Telnet over SSL uses. The default is 992, which is the well-known port
number.
Zobrazit stránku 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 219 220

Komentáře k této Příručce

Žádné komentáře