Cisco 3002 - VPN Hardware Client Uživatelská příručka stáhnout pdf (Strana 121)

Administration | File Management | Swap Config Files

12-13

VPN 3002 Hardware Client User Guide

Save Target As..., Save Link As... = Save a copy of the file on your PC. Your system will prompt for a

filename and location. The default filename is the same as on the VPN 3002.

When you are finished viewing or saving the file, close the new browser window.

Delete

To delete the selected file from flash memory, click Delete. The Manager opens a dialog box for you to

confirm or cancel. If you confirm, the Manager refreshes the screen and shows the revised list of files.

Administration | File Management | Swap Config Files

This screen lets you swap the boot configuration file with the backup configuration file. Every time you

save the active configuration, the system writes it to the

CONFIG file, which is the boot configuration

file; and it saves the previous

CONFIG file as CONFIG.BAK, the backup configuration file.

To reload the boot configuration file and make it the active configuration, you must reboot the system.

When you click

OK, the system automatically goes to the Administration | System Reboot screen, where you

can reboot the system. You can also click the highlighted link to go to that screen.

Figure 12-15: Administration | Configuration File Management | Swap Config Files screen

OK / Cancel

To swap CONFIG and CONFIG.BAK files, click OK. The Manager goes to the Administration | System

Reboot

screen.

To leave the files unchanged, click

Cancel. The Manager returns to the Administration | File Management

screen.

Administration | File Management | Config File Upload

This screen lets you use HTTP (Hypertext Transfer Protocol) to transfer a configuration file from your

PC—or a system accessible from your PC—to the VPN 3002 flash memory.

This function provides special handling for configuration (

config) files. If the uploaded file has the

VPN 3002 filename

config, the system deletes any existing config.bak file, renames the existing

config file as config.bak, then writes the new config file. However, these actions occur only if the

file transfer is successful, so existing files are not corrupted.

To use these functions, you must have

Administrator or Configuration Access Rights. See the Administration

| Access Rights | Administrators

screen.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 219 220

Žádné komentáře

Cisco 3002 - VPN Hardware Client Uživatelská příručka Strana 121