Cisco 3002 - VPN Hardware Client Uživatelská příručka stáhnout pdf (Strana 179)

14-1

VPN 3002 Hardware Client User Guide

CHAPTER

Using the Command Line Interface

The VPN 3002 Hardware Client Command Line Interface (CLI) is a menu- and command-line-based

configuration, administration, and monitoring system built into the VPN 3002. You use it via the system

console or a Telnet (or Telnet over SSL) session.

You can use the CLI to completely manage the system. You can access and configure the same

parameters as the HTML-based VPN 3002 Hardware Client Manager.

This chapter describes general features of the CLI and how to access and use it. It does not describe the

individual menu items and parameter entries. For information on specific parameters and options, see

the corresponding section of the Manager in this manual. For example, to understand Ethernet interface

configuration parameters and choices, see

Configuration | Interfaces | Private/Public in Chapter 3,

Interfaces.

Accessing the CLI

You can access the CLI in two ways: via the system console or a Telnet (or Telnet over SSL) client.

Console access

To access the CLI via console:

1 Connect a PC to the VPN 3002 via an RJ-45 serial cable (which Cisco supplies with the system)

between the

Console port on the VPN 3002 and the COM1 or serial port on the PC. For more

information, see the VPN 3002 Hardware Client Getting Started manual.

2 Start a terminal emulator (e.g., HyperTerminal) on the PC. Configure a connection to COM1 with

port settings of:

9600 bits per second.

8 data bits.

No parity.

1 stop bit.

Set the emulator for VT100 emulation, or let it auto-detect the emulation type.

3 Press

Enter on the PC keyboard until you see the login prompt. (You may see a password prompt and

error messages as you press

Enter; ignore them and stop at the login prompt.)

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 219 220

Žádné komentáře

Cisco 3002 - VPN Hardware Client Uživatelská příručka Strana 179