Cisco 1750 - 1750 Router Uživatelský manuál stáhnout pdf (Strana 7)

Voice Software Enhancements for the Cisco 1750 and Cisco 1751 Routers

OL-1671-01

Supported Features

Enter the show voice port command to verify that Caller ID is configured on the FXO, FXS, and DID

voice ports:

did_1750a#show voice port 1/0

Foreign Exchange Office M1 1/0 Slot is 0, Sub-unit is 1, Port is 0

Type of VoicePort is FXO

Operation State is DORMANT

Administrative State is UP

The Last Interface Down Failure Cause is Administrative Shutdown

Description is not set

Noise Regeneration is enabled

Non Linear Processing is enabled

Non Linear Mute is disabled

Non Linear Threshold is -21 dB

Music On Hold Threshold is Set to -38 dBm

In Gain is Set to 0 dB

Out Attenuation is Set to 3 dB

Echo Cancellation is enabled

Echo Cancellation NLP mute is disabled

Echo Cancellation NLP threshold is -21 dB

Echo Cancel Coverage is set to 8 ms

Playout-delay Mode is set to default

Playout-delay Nominal is set to 60 ms

Playout-delay Maximum is set to 200 ms

Playout-delay Minimum mode is set to default, value 4 ms

Playout-delay Fax is set to 300 ms

Connection Mode is normal

Connection Number is not set

Initial Time Out is set to 10 s

Interdigit Time Out is set to 10 s

Call Disconnect Time Out is set to 60 s

Ringing Time Out is set to 180 s

Wait Release Time Out is set to 30 s

Companding Type is u-law

Region Tone is set for US

Analog Info Follows:

Currently processing none

Maintenance Mode Set to None (not in mtc mode)

Number of signaling protocol errors are 0

Impedance is set to 600r Ohm

Station name cisco, Station number 123

Caller ID Info Follows:

Standard BELLCORE

Caller ID is received after 1 ring(s)

Voice card specific Info Follows:

Signal Type is loopStart

Number Of Rings is set to 1

Supervisory Disconnect is inactive

Answer Supervision is inactive

Hook Status is On Hook

Ring Detect Status is inactive

Ring Ground Status is inactive

Tip Ground Status is inactive

Dial Type is dtmf

Digit Duration Timing is set to 100 ms

InterDigit Duration Timing is set to 100 ms

Pulse Rate Timing is set to 10 pulses/second

InterDigit Pulse Duration Timing is set to 750 ms

Percent Break of Pulse is 60 percent

GuardOut timer is 2000 ms

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Komentáře k této Příručce

Žádné komentáře

Cisco 1750 - 1750 Router Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Sítě Cisco 1750 - 1750 Router