Cha
te
5 ICIM Mode Commands
142 4025561
Rev
show provisioning
Syntax
show provisioning
Description
The show provisioning command is used to request information about how the
elements of the ICIM2 domain are currently provisioned (configured).
This command displays a list of the CLI commands needed to restore any
replacement modules in the ICIM2 domain to their current operating states. This list
can serve as a command reference to quickly configure a replacement module so that
it operates identically to the original.
The output is intended primarily for use by an element management system, which
would store the provisioning commands until needed. In the event that a module is
replaced, the system would then send the provisioning commands required to
configure the replacement module to match the operating state of the original.
Parameters
None
Access Rights Required
Read, ReadWrite, or Admin
Example
The following sample dialog shows how a network management system might send
the command, and includes a portion of a typical response. Note that the element
management system uses an inline (non-modal) command to switch from CLI to
ICIM command mode.
CLI> icim show provisioning exit
. . . .
Module Chassis 20 Slot 5 Set Control Enable On EXIT
Module Chassis 20 Slot 5 Set Control AGC On EXIT
Module Chassis 20 Slot 5 Set Control RFDrive 0 EXIT
Module Chassis 20 Slot 5 Set Control OMISet 0 EXIT
Module Chassis 20 Slot 5 Set Control Master Master EXIT
Module Chassis 20 Slot 5 Set Control CWMode Off EXIT
Module Chassis 20 Slot 5 Set Control LenMode Off EXIT
. . . .
Komentáře k této Příručce