Cisco GoQAM Technické informace stáhnout pdf (Strana 102)

Cha

4 Module Mode Commands

78 4025561

Rev

set module

Syntax

set module CLLI clliString

Description

The set module command is used to define a Common Language Location Identifier

(CLLI) code for a specified module. This helps ensure compatibility with

telecommunications element management systems that use CLLI codes to identify

and geographically locate devices. Once defined, the set module command can be

used to refresh or modify the CLLI code for each module as needed.

Note: The set module command is only supported by current generation application

modules having firmware version CCB3. To verify module firmware versions, use

the ICIM mode show domain command to display a parameter listing for all

module parameters in the ICIM2 domain, and then confirm the value CF_CCB3 in

the CODEREV column of the listing. For further details, see show domain (on page

135).

Parameters

The clliString parameter can be any string of up to 20 characters. The string may

include space characters if surrounded by quote symbols (e.g., "with space"). The

Telcordia standard specifies an 11-character alphanumeric code. For additional CLLI

information, visit the Telcordia web site at the following URL:

 http://www.telcordia.com

Access Rights Required

ReadWrite or Admin

Examples

The sample dialog below shows how an element management system might set the

CLLI code for an optical switch module located in chassis 10, slot 5 in central office

56 in Denver, Colorado:

*/* MODULE> chassis 10 slot 5

10/05 MODULE> set module CLLI DNVRCO56OSW

SUCCESS!

MODULE>

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 307 308

Žádné komentáře

Cisco GoQAM Technické informace Strana 102