Cisco 2924C - Catalyst Switch Specifikace stáhnout pdf (Strana 311)

9-17

Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide

78-6511-05

Chapter 9 Troubleshooting

Recovery Procedures

Step 16 Enter the password of the failed command switch, and press Return.

Note The password can be from 1 to 25 alphanumeric characters, can start

with a number, is case sensitive, allows spaces, but ignores leading

spaces.

Enter enable secret: secret_password

Step 17 Enter Y to enter a Telnet password:

Would you like to configure a Telnet password? [yes] y

Note The password can be from 1 to 25 alphanumeric characters, is case

sensitive, allows spaces, but ignores leading spaces.

Step 18 Enter the Telnet password, and press Return:

Enter Telnet password: telnet_password

Step 19 Enter Y to configure the switch as the cluster command switch. Enter N to

configure it as a member switch or as a standalone switch.

Note If you enter N, the switch appears as a candidate switch in Cluster

Builder. In this case, the message in Step 20 is not displayed.

Would you like to enable as a cluster command switch? y

Step 20 Assign a name to the cluster, and press Return.

Enter cluster name: cls_name

Note The cluster name can be 1 to 31 alphanumeric characters, dashes, or

underscores.

Step 21 The initial configuration is displayed:

The following configuration command script was created:

ip subnet-zero

interface VLAN1

ip address 172.20.153.36 255.255.255.0

1 2 ... 306 307 308 309 310 311 312 313 314 315 316 ... 359 360

Žádné komentáře

Cisco 2924C - Catalyst Switch Specifikace Strana 311