Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Datový list stáhnout pdf (Strana 16)

642-531

Which command represents a valid configuration step to permit Sensor IDS6 to monitor traffic sent to Server

Certkiller 7?

A. 4000>(enable) set rspan destination 99 3/24

B. 4000>(config)# monitor session 2 destination interface fastEthernet 3/24

C. 6500(config)# remote-span 99

D. 6500>(enable) set rspan source 3/5 99 tx create

E. 4000>(enable) set rspan source vlan 99 destination interface fastEthernet 3/24

Answer: D

Explanation:

Configuring RSPAN from the CLI

The first step in configuring an RSPAN session is to select an RSPAN VLAN for the RSPAN session that does

not exist in any of the switches that will participate in RSPAN. With VTP enabled in the network, you can

create the RSPAN VLAN in one switch and VTP propagates it to the other switches in the VTP domain.

Use VTP pruning to get efficient flow of RSPAN traffic or manually delete the RSPAN VLAN from all trunks

that do not need to carry the RSPAN traffic.

Once the RSPAN VLAN is created, you configure the source and destination switches using the set rspan

command.

To configure RSPAN source ports, perform this task in privileged mode:

Task Command

Step1

Configure

RSPAN source

ports.

set rspan

source{mod/ports...

Use this command

on each of

vlans... | sc0}

{rspan_vlan} [rx |

the source

switches

participating

tx| both] [multicast

{enable |

in RSPAN. disable}] [filter

vlans...] [create]

Reference:Cisco Courseware 5-25

QUESTION 40

Study the exhibit below carefully:

According to the exhibit which command represents a valid configuration step to permit the IDSM-2 to monitor

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 122 123

Žádné komentáře

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Datový list Strana 16