Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Datový list stáhnout pdf (Strana 118)

642-531

Answer: C

Explanation:

The fixup protocol commands let you view, change, enable, or disable the use of a service or protocol through

the PIXFirewall. The ports you specify are those that the PIXFirewall listens at for each respective service.

Reference: Cisco PIX Firewall Command Reference, Version 6.3

Note:In Appendix B of the Cisco Secure Intrusion Detection System 4 Fixup protocol is not talked about.

QUESTION 265

Debugging a PIX is what you want to do to resolve a problem.

What command would you use to display the current state of tracing?

A. show debug

B. debug all

C. all on debug

D. debug crypto

Answer: A

Explanation:

The debug command lets you view debug information. The show debug command displays the current state of

tracing. You can debug the contents of network layer protocol packets with the debug packetcommand

Reference: Cisco PIX Firewall Command Reference, Version 6.3

. Note: in Appendix B of the Cisco Secure Intrusion Detection System 4 Debugging is not talked about.

QUESTION 266

RIP uses a port to establish communications. If you were to block it with your Firewall, what port would you be

concerned about?

A. Port 345

B. Port 345

C. Port 520

D. Port 354

Answer: C

Explanation:

Port 520 is the Routing Information Protocol port.

Reference: Cisco PIX Firewall Software - Introduction

Note: Rip is not talked about in this manner in the course manual 4

QUESTION 267

Exhibit:

If you were looking at the back of your PIX firewall and saw the following plate, what model of PIX would you

be working on?

1 2 ... 113 114 115 116 117 118 119 120 121 122 123

Žádné komentáře

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Datový list Strana 118