Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Instalační příručka stáhnout pdf (Strana 68)

Chapter 2 Installing and Starting the Switch

Installing the GBIC Modules

2-22

Catalyst 3550 Multilayer Switch Hardware Installation Guide

78-11358-03

Table or Shelf Mounting

Follow these steps to install the switch on a table or shelf:

Step 1 Locate the adhesive strip with the rubber feet in the mounting-kit envelope.

Attach the four rubber feet to the recessed areas on the bottom of the unit.

Step 2 Place the switch on the table or shelf near an AC power source.

After the switch is mounted on the table or shelf, see the “Powering On the

Switch” section on page 2-24 to complete the installation.

After the switch is mounted on the table or shelf, see the “Powering On the

Switch” section on page 2-24 to complete the installation.

Installing the GBIC Modules

Figure 2-21, Figure 2-22, and Figure 2-23 show how a GBIC module is inserted

into a GBIC module slot on the switch. For detailed instructions on installing,

removing, and cabling the GBICs (1000BASE-X module, 1000BASE-T module,

or the GigaStack module), refer to your GBIC documentation.

Caution To prevent electrostatic-discharge (ESD) damage when installing GBICs, follow

your normal board and component handling procedures.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 149 150

Žádné komentáře

Cisco WS-C3550-24-FX-SMI - Catalyst 3550 100BASE-FX Switch Instalační příručka Strana 68