Cisco Network Convergence System 6000 Series Instalační příručka stáhnout pdf (Strana 31)

5-31

Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide

Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards

Installing and Removing a Line Card

Figure 5-12 Installing a LC

Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to the ESD connection socket

on the front side of the chassis (Figure 2-4). You can also connect the ESD-preventive wrist strap leash

to any bare metal surface on the chassis.

Step 2 Remove the impedance carrier (see the “Removing an Impedance Carrier” section on page 5-7) and set

it aside.

Note Remove only one impedance carrier and install one LC at a time. Be sure to verify that each LC

is fully installed and secured before installing another card.

1 Direction of insertion 3 Captive screw

2 Ejector lever

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Žádné komentáře

Cisco Network Convergence System 6000 Series Instalační příručka Strana 31