Cisco Network Convergence System 6000 Series Instalační příručka stáhnout pdf (Strana 13)

5-13

Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide

Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards

Installing Fabric Cards

• Installing a NC6-FC Fabric Card, page 5-13

• Verifying the Installation of a NC6-FC Fabric Card, page 5-16

• About Line Cards, page 5-22

Installing a NC6-FC Fabric Card

Prerequisites

Before performing this task, open the cosmetic doors, if installed.

Required Tools and Equipment

• ESD-preventive wrist strap

• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver

• Fabric Card (Cisco PID NC6-FC)

Steps

To install an FC (Figure 5-5), perform the following steps:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Žádné komentáře

Cisco Network Convergence System 6000 Series Instalační příručka Strana 13