Cisco CX-FEIP-2TX= Installation and con?guration Uživatelská příručka stáhnout pdf

Doc. No.

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

Cisco Systems, Inc.

Corporate Headquarters

Fast Ethernet Interface Processor (FEIP)

Installation and Conﬁguration

Product Numbers: CX-FEIP-1TX=, CX-FEIP-2TX=, CX-FEIP-1FX=, CX-FEIP-2FX=

This conﬁguration note is a standalone publication that provides instructions for installing and

conﬁguring the Fast Ethernet Interface Processor (FEIP) in all Cisco 7000 series routers and

Cisco 7500 series routers. (For speciﬁc compatibility requirements, refer to the section “Software

and Hardware Prerequisites,” on page 3.)

Note For convenience throughout this publication, FEIP-1TX, FEIP-2TX, FEIP-1FX, and

FEIP-2FX are referred to as FEIP, with speciﬁc differences clearly noted.

Included in this conﬁguration note are steps for FEIP hardware installation and cable connection,

and basic FEIP conﬁguration steps and examples. A table of contents is included so you can more

easily ﬁnd what you need.

For additional descriptions of interface subcommands and conﬁguration options available for Fast

Ethernet (FE) interfaces, refer to the appropriate Cisco IOS software conﬁguration and command

reference publications listed in the section “If You Need More Information” on page 2.

78-1812-08

1 2 3 4 5 6 ... 39 40

Shrnutí obsahu

Strany 1 - Installation and Conﬁguration

Strany 2 - Document Contents

10 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationInstallation PrerequisitesWhat Is the Cisco 7000 Series?The Cisco 7000 series

Strany 3

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 11What Is the Cisco 7500 Series?In the 5-slot Cisco 7010 (Figure 3), slots 0

Strany 4

12 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationInstallation PrerequisitesIn the Cisco 7507 (see Figure 5), slots 0 and 1 and

Strany 5 - Safety Guidelines

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 13What Is the Cisco 7500 Series?In the Cisco 7513 (see Figure 6), slots 0 thr

Strany 6

14 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationWhat Is the FEIP?What Is the FEIP?The FEIP provides up to two 100-Mbps, IEEE

Strany 7 - Orientation Shown)

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 15FEIP LEDsNote Each FEIP is a ﬁxed conﬁguration; therefore, individual port

Strany 8 - Fast Ethernet Overview

16 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationWhat Is the FEIP?Following are the three status LEDs and an explanation of wh

Strany 9

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 17FEIP Receptacles, Cables, and PinoutsThe RJ-45 connection does not require

Strany 10 - Installation Prerequisites

18 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationWhat Is the FEIP?Depending on your RJ-45 interface cabling requirements, use

Strany 11 - ROUTE SWITCH PROCESSOR

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 19FEIP Receptacles, Cables, and PinoutsDepending on the type of media you use

Strany 12

2 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationDocument ContentsDocument ContentsThis publication includes the following sect

Strany 13 - ROUTE SWITCH PROCESSOR 2

20 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationFEIP InstallationFEIP InstallationThe following sections describe the procedu

Strany 14

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 21Removing an FEIPRemoving an FEIPYou need not shut down the interface or the

Strany 15 - FEIP LEDs

22 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationFEIP InstallationTo remove an FEIP or interface processor, follow these steps

Strany 16 - What Is the FEIP?

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 23Attaching Fast Ethernet Interface CablesStep 2 Hold the FEIP handle with on

Strany 17 - RJ-45 connector

24 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationFEIP InstallationConnect RJ-45, SC (FEIP-1FX or -2FX), or MII cables as follo

Strany 18

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 25Attaching Fast Ethernet Interface CablesFigure 19 Connecting MII or SC Cabl

Strany 19

26 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationFEIP InstallationUsing LEDs to Check FEIP StatusThe FEIP has four status LEDs

Strany 20 - FEIP Installation

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 27Configuring the Fast Ethernet Interfaces*Step 4 If an enabled LED still fai

Strany 21 - Removing an FEIP

28 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationConﬁguring the Fast Ethernet Interfaces*Selecting Interface Processor Slot, I

Strany 22 - Installing an FEIP

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 29Configuring Interfaces—Descriptions and ExamplesConﬁguring Interfaces—Descr

Strany 23

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 3Installation Prerequisites• To view Cisco documentation or obtain general in

Strany 24 - FAST ETHERNET

30 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationConﬁguring the Fast Ethernet Interfaces*FE half-duplex operation is the defau

Strany 25

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 31Checking the ConfigurationThe RJ-45 connection is the default for FEIP-2TX

Strany 26

32 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationConﬁguring the Fast Ethernet Interfaces*Using show Commands to Display Interf

Strany 27

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 33Checking the ConfigurationThe show controllers cbus command displays inform

Strany 28

34 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationConﬁguring the Fast Ethernet Interfaces*The show version (or show hardware) c

Strany 29

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 35Checking the ConfigurationTo determine which type of interfaces are install

Strany 30

36 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationUpgrading FEIP MicrocodeUsing the ping Command to Verify Network Connectivity

Strany 31 - Checking the Conﬁguration

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 37Upgrading FEIP MicrocodeTo compare the size of the microcode image and the

Strany 32

38 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationUpgrading FEIP MicrocodeStep 4 Use the show ﬂash command to verify that the m

Strany 33 - Checking the Configuration

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 39Cisco Connection OnlineCisco Connection OnlineCisco Connection Online (CCO)

Strany 34

4 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationInstallation PrerequisitesEach FEIP is a ﬁxed conﬁguration; therefore, individ

Strany 35

40 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationCisco Connection Online

Strany 36 - Upgrading FEIP Microcode

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 5Safety Guidelines• Do not perform any action that creates a potential hazard

Strany 37

6 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationInstallation PrerequisitesGuidelines for Interface Processor Installation and

Strany 38

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 7Guidelines for Interface Processor Installation and RemovalFigure 1 Ejector

Strany 39 - Cisco Connection Online

8 Fast Ethernet Interface Processor (FEIP) Installation and ConﬁgurationInstallation PrerequisitesMicrocode OverviewThe FEIP microcode (ﬁrmware) is an

Strany 40

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 9IEEE 802.3u 100BASE-T SpecificationsIEEE 802.3u speciﬁes the following diffe