Cisco Catalyst 1800 Guide Uživatelský manuál stáhnout pdf (Strana 2)

2-2 Catalyst 1800 Token Ring Switch User Guide

Using the Console Interface

Step3 Power up the Cisco Catalyst 1800.

Step4 When the Cisco Catalyst 1800 has completed booting up, you are prompted to enter a

password.

Step5 The system default password is public.

Using the Console Interface

This section describes how to use the console interface of the Cisco Catalyst 1800. The console

interface is a standard male DB-9 connector and provides access to menu commands via a PC or VT

series compatible terminal.

You can access all configuration parameters available in the SNMP MIBs through the console

interface. All configurable parameters are stored in non-volatile RAM (NVRAM) for access on

subsequent boots of the Cisco Catalyst 1800.

The console interface combines a menu display with a command line input function. The menu

selections are made through the fully interactive command line interface.

You can access menus by entering a menu selection at the console prompt (Catalyst 1800>).

When the desired menu appears, enter the selection on the command line with the required

parameters.

For example, to configure port 1 with IP information, enter this command at the prompt:

Configure ip 1 address 204.242.251.3

The next menu will display above the command line each time you enter a keyword and press < SP>.

The preceding sample displays the Configuration menu, the Configuring IP Parameters menu, and

the IP Parameters Display menu. A more detailed example is provided in Quick Configuration on

page 2-5. Unless otherwise noted, all configuration parameters take effect immediately.

Abbreviated Text Recognition

You can specify a command by using a shorthand known as Abbreviated Text Recognition. This

means that the Cisco Catalyst 1800 allows you to enter the minimal number of characters that it takes

to recognize a certain parameter. It then presents you with the next screen.

Therefore, you could also enter the preceeding example by using the following syntax:

c i 1 a 204.242.251.3

Note If the abbreviation is too short for recognition, the system erases it. Retype the entry,

supplying additional characters.

Flow Control Off

Table2-1 Terminal Emulation Parameters (Sheet 2 of 2)

Parameter Value

1 2 3 4 5 6 7 ... 11 12

Žádné komentáře

Cisco Catalyst 1800 Guide Uživatelský manuál Strana 2