Cisco 7507 Uživatelský manuál stáhnout pdf (Strana 27)

TheRSP hastwo PCCard slots—slot 0 and slot 1—into whichyou caninstall aFlash memorycard. Inthe RSP2,

RSP4, and RSP8, the orientation is vertical. PC Card slot 0 is on the left and slot 1 is on the right (as shown).

Note A Flash memory card can be inserted and

removed with the system power on. Both PC Card

slots can be used at the same time.

Step 1 To eject the card, press the appropriate

eject button until the card is free of the

connector at the back of the slot (see C).

Step 2 Removethe card fromthe slotand place it

in an antistatic bag to protect it.

Step 3 Face the front panel of the RSP, and hold

theFlashmemorycard with theconnector

end of the card toward the slot (see A).

The label should face right.

Note The Flash memory card is keyed and cannot

be seated the wrong way. The eject button will not

pop out if the card is not properly inserted.

Step 4 Insert the card into the appropriate slot

until the card completely seats in the

connector at the back of the slot and the

eject button pops out toward you (see B).

Note Thecard does notinsert alltheway insidethe

RSP; a portion of the card remains outside of the

slot. Do not attempt to force the card past this point.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Žádné komentáře

Cisco 7507 Uživatelský manuál Strana 27