Cisco 12012 Technické informace stáhnout pdf (Strana 41)

show controllers (line card image)

Cisco 12000 Series Gigabit Switch Routers 53

Command Mode

Privileged EXEC

Usage Guidelines

This command was added in Cisco IOS Release 11.2 GS to support the Cisco 12000 series Gigabit

Switch Routers.

Note This information is of use only to technical support representatives in analyzing crashes in the

ﬁeld. It is included here in case you need to read the displayed statistics to an engineer over the

phone.

Sample Displays

Because you are executing this command on the line card, you must use the execute-on command

to perform the show command, or you must connect to the card using the attach command. All

examples in this section use the execute-on command

The following is partial sample output from the show controllers atm command.

Router# execute-on slot 4 show controllers atm 0

TX SAR (Beta 1.0.0) is Operational;

RX SAR (Beta 1.0.0) is Operational;

Interface Configuration Mode:

STS-12c

Active Maker Channels: total # 6

VCID ChnnlID Type OutputInfo InPkts InOAMs MacString

1 0888 UBR 0C010010 0 0 08882000AAAA030000000800

2 0988 VBR 04010020 0 0 09882000

3 8BC8 UBR 0C010030 0 0 8BC82000AAAA030000000800

4 0E08 UBR 0C010040 0 0 0E082000AAAA030000000800

10 1288 VBR 040100A0 0 0 12882000

11 8BE8 VBR 0C0100B0 0 0 8BE82000AAAA030000000800

SAR Total Counters:

total_tx_idle_cells 215267 total_tx_paks 0 total_tx_abort_paks 0

total_rx_paks 0 total_rx_drop_paks 0 total_rx_discard_cells 15

Switching Code Counters:

total_rx_crc_err_paks 0 total_rx_giant_paks 0

total_rx_abort_paks 0 total_rx_crc10_cells 0

total_rx_tmout_paks 0 total_rx_unknown_paks 0

total_rx_out_buf_paks 0 total_rx_unknown_vc_paks 0

l3 Displays Layer 3 ASIC information.

pos {framers | queues | registers |

rxsram port-number

queue-start-address [queue-length] |

txsram port-number

queue-start-address [queue-length]}

Displays the POS framer registers, queue information,

ASIC registers, receive queue SRAM, or transmit queue

SRAM information. When you display the transmit or

receive queue information, you must specify a port (valid

range is 0 to 3) and the queue SRAM logical starting

address. You can also optionally specify the queue SRAM

length.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Cisco 12012 Technické informace Strana 41

Komentáře k této Příručce