Cisco WS-X4604-GWY - VoIP Gateway Specifikace stáhnout pdf (Strana 40)

2-14

Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note

OL-3008-01

Chapter 2 Installing the Access Gateway Module

Connecting the Voice and WAN Interface Modules

Figure 2-7 Connecting a 1- Port Serial Module (WIC-1T)

Step 4

Power on the AGM.

Step 5 Verify that the CONN LED goes on, indicating that the serial port on the module detects the WAN serial

connection.

Table 2-4 describes the serial WAN interface module LED.

Voice Interface Modules

This section describes how to connect the following voice interface modules:

• Connecting the 2-Port FXS Voice Interface Modules, page 2-14

• Connecting the 8-Port RJ21 FXS Voice Interface Modules, page 2-16

• Connecting the 2-Port FXO Voice Interface Modules, page 2-19

• Connecting the 2-Port E/M Voice Interface Modules, page 2-20

• Connecting the 2-Port ISDN BRI Modules, page 2-21

Connecting the 2-Port FXS Voice Interface Modules

This section describes how to connect and verify the status of the 2-port FXS voice interface module

(VIC-2FXS or VIC-2FXS-EU).

SERIAL

Serial transition

cable

DSU/CSU or

other DCE

EIA/TIA-232, EIA/TIA-449, V.35,

X.21, or EIA-530 connector

58519

Synchronous serial

port (DB-60)

CONN LED

CONN

Table 2-4 Serial WAN Interface Module LED

LED Description

CONN Green indicates that the serial port detects the WAN serial connection.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 165 166

Žádné komentáře

Cisco WS-X4604-GWY - VoIP Gateway Specifikace Strana 40