Cisco WS-X4604-GWY - VoIP Gateway Specifikace Strana 141
- Strana / 166
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
8-13
Cisco Catalyst 4000 Access Gateway Module Installation and Configuration Note
OL-3008-01
Chapter 8 Configuring the DSP Farm
Troubleshooting the AGM
tmd( 31860A8 ): status 0 length 0 address 0
tmd( 31860B0 ): status 0 length 0 address 0
tmd( 31860B8 ): status 0 length 0 address 0
tmd( 31860C0 ): status 0 length 0 address 0
tmd( 31860C8 ): status 0 length 0 address 0
tmd( 31860D0 ): status 0 length 0 address 0
tmd( 31860D8 ): status 0 length 0 address 0
tmd( 31860E0 ): status 0 length 0 address 0
tmd( 31860E8 ): status 0 length 0 address 0
tmd( 31860F0 ): status 0 length 0 address 0
tmd( 31860F8 ): status 2000 length 0 address 0
Mcc channel 96 channel counters:
rx_index: 0x0 tx_index: 0x2A8E tx_total: 0x2A8E num_rx_frame: 0xC983D2B
total_rx: 0xC983D2B mrf_violation: 0x0 bsy_dropped: 0x0 rxf_errored: 0x0
rxf_not_last: 0x0 rxf_complete: 0xC983D2B tx_free: 0x10
timer4: 0x61C3 risc_timer15: 0x7DC7
buffer size 1524
Troubleshooting Hardware
Use the show hardware command to display information on the installed hardware:
Gateway# show hardware
Cisco Internetwork Operating System Software
IOS (tm) C4GWY Software (C4GWY-IO3SX3-M), Experimental Version 12.1(20000606:174737)
[winterfi-chopin_b7 101]
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Tue 06-Jun-00 12:22 by winterfi
Image text-base: 0x80020088, data-base: 0x809F47D0
ROM: System Bootstrap, Version 12.0(20000421:164624) [manlunas-chopin_b 108], DEVELOPMENT
SOFTWARE
Gateway uptime is 1 hour, 45 minutes
System returned to ROM by power-on
Running default software
cisco x4604 (MPC8260) processor (revision 0x03) with 49152K/16384K bytes of memory.
Processor board ID 0000 (1314672220)
Bridging software.
X.25 software, Version 3.0.0.
1 Virtual Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
1 Gigabit Ethernet/IEEE 802.3 interface(s)
Voice FXS interface(s)
24 Voice resource(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x0
Troubleshooting TDM
Use the show tdm command to display a TDM slot.
- Cisco Catalyst 4000 1
- Access Gateway Module 1
- CONTENTS 3
- Contents 4
- Audience 9
- Organization 9
- Conventions 10
- Safety Overview 11
- Related Documentation 12
- Obtaining Documentation 13
- Documentation Feedback 14
- Cisco.com 14
- Technical Assistance Center 15
- Overview 17
- IP Telephony Campus 18
- Large Branch Office 18
- • the console port on the AGM 19
- Hardware Features 20
- Cisco Catalyst 4000 DSP Set 21
- Data Interface Modules 21
- Voice Interface Modules 22
- Signaling Support on AGM 23
- Switch-Type Support on AGM 23
- Software Features 24
- Security 25
- Resiliency 25
- Network Management Support 26
- Preparing to Install the AGM 27
- Installing the AGM 29
- Hot-Swapping Features 31
- Checking the AGM Operation 32
- Power Supply 1 34
- Power Supply 2 34
- WAN Interface Modules 35
- SEE MANUAL 36
- INSTALLATION 36
- Straight-through 41
- RJ-11-to-RJ-11 cable 41
- RJ-11 ports 41
- RJ-11 wall jack 41
- RJ-21 Connectors 42
- Velcro strap 43
- ConfigurableNot used 45
- RJ-48S ports 47
- RJ-48S wall jack 47
- RJ-48C ports 48
- NT1 device 48
- RJ-45-to-RJ-45 cable 48
- S/T port 48
- RJ-48C-to-RJ-48C cable 50
- RJ-48C wall jack 50
- Booting the AGM 53
- Accessing the AGM 54
- Configuring the Console Port 55
- Connecting a Terminal 56
- Connecting a Modem 56
- Using the Cisco IOS CLI 57
- Getting Help 58
- Command Modes 58
- Gateway(config-if)# 59
- (config 59
- Gateway(config-dial-peer)# 59
- Saving Configuration Changes 60
- Table 4-2 ISDN Switch Types 68
- Configuring T1 Interfaces 69
- Configuring E1 Interfaces 71
- Preparing to Configure VoIP 75
- Configuring Voice Interfaces 76
- MGCP Configuration 77
- Enabling MGCP 78
- • E&M Wink Start 81
- • E&M Delay Start 81
- H.323 Gateway Configuration 86
- FXS Emulation Example 90
- FXO Emulation Example 90
- E&M Emulation Example 91
- Configuring ISDN BRI Lines 92
- Gateway 1 Configuration 95
- T1/E1 Configuration (H.323) 96
- T1/PRI Configuration Example 97
- E1/PRI Configuration Example 98
- Configuration for AGM AGLB-1 99
- Configuration for AGM AGLB-2 100
- FXO Connection to PSTN 101
- San Jose Salt Lake City 102
- AGM SLC Configuration 103
- OL-3008-01 104
- Configuring FXS Voice Ports 106
- Validating the Configuration 107
- Fine-Tuning FXS Voice Ports 108
- Activating the Voice Port 110
- Sample Configuration 110
- Verifying the Configuration 120
- Sample Configurations 121
- Configuration File for Peer 1 124
- Configuration File for Peer 2 126
- Configuring the DSP Farm 129
- IP Telephony Gateway Mode 130
- Conferencing Service 131
- Transcoding Service 132
- Troubleshooting the AGM 137
- Troubleshooting Controller 138
- Troubleshooting Hardware 141
- Troubleshooting TDM 141
- Troubleshooting DSP 142
- SIMM 3 DSP 12–17 143
- SIMM 4 DSP 18–23 143
- Entering ROM Monitor Mode 145
- Configuring for Autoboot 146
- ROM Monitor Commands 147
- Debugging Commands 150
- Cookie Commands 151
- Upgrading the ROM Monitor 157
- Using Loss Plan Defaults 159
- Transmission Loss Plan 160
- Console Connector Pinouts 161
- Management Port Pinouts 161
- Identifying a Rollover Cable 163
- Connecting to a PC 164
- Connecting to a Terminal 164
Související produkty a manuály pro Brány / ovladače Cisco WS-X4604-GWY - VoIP Gateway
Brány / ovladače Cisco DPA 7610 Uživatelský manuál
(14 stránky)
(14 stránky)
Brány / ovladače Cisco DPC3925 Uživatelský manuál
(90 stránky)
(90 stránky)
Brány / ovladače Cisco AS5850 Instalační příručka
(30 stránky)
(30 stránky)
Brány / ovladače Cisco DPA 7610 Uživatelský manuál
(20 stránky)
(20 stránky)
Brány / ovladače Cisco EPC2425 Uživatelský manuál
(25 stránky)
(25 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce